Manual Pdf: Xmtg-2000 Temperature Controller

Moves the cursor to the digit you wish to change for faster setting. 4. How to Program the XMTG-2000

Displays the current measured temperature in red. SV (Set Value): Displays the target temperature in green. SET Key: Used to enter parameter menus and confirm changes.

Before installation, ensure your unit matches your system requirements: ±0.5% Full Scale Input Types: K, J, E, S, Pt100 (Selectable via settings) xmtg-2000 temperature controller manual pdf

Use the , ▲ , and ▼ keys to reach your desired temperature. Press SET again to save. Accessing the Parameter Menu

When looking at the rear of the XMTG-2000, the terminal numbering usually follows this standard layout (always verify with the diagram printed on your specific unit’s casing): Terminals 1 and 2 (Standard AC input). Relay/SSR Output: Terminals 3, 4, and 5. Sensor Input: Thermocouple: Terminals 8 (+) and 9 (-). RTD (Pt100): Terminals 7, 8, and 9. Alarm: Terminals 6 and 7 (depending on model variation). 3. Front Panel Controls Moves the cursor to the digit you wish

Check if the "OUT" light is blinking. If it is, the controller is sending a signal, but your heater or SSR may be faulty.

Used in On/Off control to prevent rapid cycling. SV (Set Value): Displays the target temperature in green

The controller will cycle the heat on and off several times to learn the thermal inertia of your system. Once finished, it will automatically return to normal operation with optimized PID values. 6. Troubleshooting Common Errors