Xh-m608 Manual !!hot!! -

The relay stays closed to power your load until the battery hits the undervoltage limit. 3. Programming & Modes

Connect the positive (+) and negative (–) leads of your 6-40V battery to the module's battery input terminals. Xh-m608 Manual

The relay on the board should be placed "in-line" with one of the wires (typically the positive) of your charger or load. The relay stays closed to power your load

Relay closes when voltage ≥ P2 (upper limit) and opens when voltage ≤ P1 (lower limit). Setting the Limits (P1 & P2) The relay on the board should be placed

Sets the trigger for starting a charge or stopping a discharge.

Understanding the limits of your hardware is critical for preventing electrical failure. DC 6V to 40V. Display & Control Accuracy: 0.1V.

The module uses a menu system (P0 to P3) to define its behavior. Use the button to navigate and the + / – buttons to adjust values. P0: Operating Mode Selection