Simrad Rf300 Installation Manual Repack -

Before securing the unit, rotate the transmitter lever until the alignment marks are perfectly centered. These marks should be opposite the cable entry point of the feedback unit. Tiller Arm Connection:

The unit connects directly to the rudder feedback terminals on your Simrad Autopilot Computer (such as the AC12 or AC42). simrad rf300 installation manual

Drill and tap the rudder tiller arm (typically using a 4.2 mm drill and 5 mm tap). Before securing the unit, rotate the transmitter lever

Ensure you create a "drip nose" (a loop in the cable where it enters the unit) to prevent water from running down the cable and into the feedback housing or connections. 3. System Calibration & Setup Drill and tap the rudder tiller arm (typically using a 4

Slowly turn the helm from lock to lock by hand. Verify that the rod does not bind and that there is no mechanical interference throughout the full range of motion. 2. Wiring and Connection The RF300 uses a unique two-wire frequency-based signal .

The goal of the mechanical installation is to maintain a between the rudder movement and the feedback unit.