Connect your device to your Mac and enter standard DFU mode.
It allows users to dump SecureROM, decrypt keybags using GID/UID keys, and demote devices to enable JTAG debugging. Prerequisites for Mac Users
Press Volume Up, then Volume Down, then hold the Side button until the screen goes black. Immediately hold Side + Volume Down for 5 seconds, then release Side while continuing to hold Volume Down. 3. Run the Pwn Command Open Terminal and navigate to your ipwndfu folder: cd /path/to/ipwndfu-folder ./ipwndfu -p Use code with caution. Pwndfu Mac
iPwndfu is an open-source tool designed for macOS and Linux that exploits the BootROM—the first code that runs when an iOS device powers on. Unlike standard Recovery or DFU modes, Pwned DFU removes signature checks, meaning the device will accept unsigned or modified code from a computer.
To successfully use iPwndfu on a Mac, you must meet specific hardware and software requirements: Connect your device to your Mac and enter standard DFU mode
You must use a physical cable (USB-A to Lightning is often more reliable than USB-C for this specific exploit).
Most modern versions use checkm8 , a permanent, unpatchable exploit for millions of iOS devices (A5 through A11 chips). Immediately hold Side + Volume Down for 5
If the exploit fails (which is common due to race conditions), simply reboot the device and try again. 4. Optional: Remove Signature Checks To allow the device to boot custom firmware, run: ./ipwndfu --rmsigchecks Use code with caution. Troubleshooting Common Mac Issues