Maximum Capacity: 8GB (2 x 4GB modules)Speed: DDR3 800 / 1066 MHzArchitecture: Dual-channel support
Move the jumper cap from pins 1-2 (Normal) to pins 2-3 (Clear). Wait 15 seconds. Return the jumper to pins 1-2. Plug in and restart. Rear I/O Port Layout The back panel of the H-IG41-uATX typically includes: h-ig41-uatx rev 1.1 manual
USB Headers (F_USB1 / F_USB2)These allow for front-case USB 2.0 ports. Each header supports two USB ports. Ensure the red wire (VCC) aligns with Pin 1. Maximum Capacity: 8GB (2 x 4GB modules)Speed: DDR3
Note: This board is often picky with "high-density" RAM. For best results, use "low-density" modules (chips on both sides of the stick). Internal Headers and Connectors Plug in and restart
The H-IG41-uATX Rev 1.1 supports a variety of 65nm and 45nm Intel processors. Note that the maximum Thermal Design Power (TDP) for this board is typically 65W or 95W depending on the specific BIOS version.