Manual ~repack~ — Gemel Txshs User

If you are transporting your bike on a trailer or train, you can disable the motion sensor while keeping the alarm armed: Arm the alarm by pressing . Press Button 1 again within the activation phase.

If your remote stops responding (often after a battery change or if buttons were pressed over 256 times out of range), use this procedure to re-pair it: Gemel Txshs User Manual

The TXSHS remote typically features two buttons and a status LED: Used to arm the system. Button 2 (Smooth): Used to disarm the system. If you are transporting your bike on a

Press both Button 1 and Button 2 simultaneously. Hold them for approximately 10 seconds until the LED on the remote stops flashing. Button 2 (Smooth): Used to disarm the system

Hi all, As I mentioned in one of my previous posts I was going to change the two small batteries in my BMW alarm box (Gemel TXSHS) Gemel TXSHS alarm operating advice needed - UKGSer